Clicking the Arm button will initialize the plug-in instances then the hardware and stay in the Armed state until the user clicks the Start button. In this case, Skydel will simply display a message inviting you to add an output and select signals. You may get an error if you haven’t selected an Output. Clicking the Start button will begin the simulation. ![]() Ready means that the simulator is ready to start. Voltage Controlled, Temperature Compensated Oscillator GNSS Signal Generator is a device that is able to create simulated satellite signals and generate real RF signalsĪmplitude of In-Phase (I) and Quadrature (Q) of carrier Appendix A - Important changes introduced in version 21.3 Network Card Driver: 10 GbE Intel X520-DA2 Nvidia GPU Driver for Ubuntu 18.04 and 20.04 (Automatic) Ettus X300/X310 NI USRP-294xR/295xR Firmware (FPGA image) Ettus N310 Firmware (File system and FPGA image) ![]() Ettus X300/X310 National Instruments USRP-294xR/USRP-295xR Requirements for National Instruments USRP-294xR/USRP-295xR Time Offset Too Small (or Sampling Rate Too Low) Synchronize Simulators with a GPS Timing receiver Synchronize configuration between master and slaves
0 Comments
Leave a Reply. |